Toyota Tundra I facelift (2002-2006) detection switch transfer shift actuator (on transfer case) (rear of trans) wiring diagram
This page shows the only wiring diagram for the component.detection switch transfer shift actuator (on transfer case) (rear of trans), which is found in the car Toyota Tundra I facelift (2002-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
detection switch transfer shift actuator (on transfer case) (rear of trans) wiring diagram (1 of 1)
ABS ACTUATOR WITH ECU (W/O VSC) (RIGHT REAR OF ENGINE COMPT)
ADD
ADD ACTUATOR (LEFT FRONT OF ENGINE)
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BLU/BLK WIRE
BLU/RED WIRE
BRN/YEL WIRE
COMBINATION METER
DETECTION SWITCH
DETECTION SWITCH TRANSFER SHIFT ACTUATOR (ON TRANSFER CASE) (REAR OF TRANS)
DIODE (A/T) (BEHIND UPPER LEFT SIDE OF DASH)
DRIVER SIDE J/B (LOWER LEFT SIDE OF DASH)
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
EXI
FUSE
GAUGE FUSE
GRN WIRE
GRN/ORG WIRE
GRN/RED WIRE
GRN/YEL WIRE
GRY WIRE
H+ L-
HOT IN ON OR ACC
HOT IN ON OR START
INTEGRATION CONTROL, PANEL (BEHIND CENTER OF DASH)
J/C 10 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 12 (BEHIND UPPER RIGHT SIDE OF DASH)
J/C 13 (RIGHT KICK PANEL)
J/C 20 (BEHIND UPPER RIGHT SIDE OF DASH)
J/C 28, J/C 29 (BEHIND UPPER RIGHT SIDE OF DASH)
J/C 8 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 9 (BEHIND UPPER LEFT SIDE OF DASH)
LT GRN WIRE
LT GRN/BLK WIRE
NEUTRAL POSITION SWITCH (PART OF PARK/ NEUTRAL POSITION SWITCH)
PNK WIRE
POSITION) (LEFT SIDE OF TRANS)
RED WIRE
RED/BLK WIRE
RED/WHT WIRE
SKID CONTROL ECU (W/VSC) (BEHIND CENTER OF DASH)
SPD 2-4 PNK WIRE
SPEEDO
W/O DOOR LOCK CTRL W/ DOOR LOCK CTRL
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 4.7l, 4wd circuit, access/standard cab -> DETECTION SWITCH TRANSFER SHIFT ACTUATOR (ON TRANSFER CASE) (REAR OF TRANS)
