Toyota Tundra I (2000-2002) transfer detection switch wiring diagram
This page shows the only wiring diagram for the component.transfer detection switch, which is found in the car Toyota Tundra I (2000-2002). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transfer detection switch wiring diagram (1 of 1)
AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR (REAR OF ENGINE COMPT)
BLK WIRE
BLK/RED WIRE
BLU/RED WIRE
BRN WIRE
BRN/YEL WIRE
CRUISE CONTROL ECU (RIGHT SIDE OF ENGINE)
DRIVER SIDE J/B (BEHIND LEFT SIDE OF DASH)
ELECTRONICALLY CONTROLLED TRANSMISSION SOLENOID
GRN/BLK WIRE
GRN/RED WIRE
GRN/WHT WIRE
GRN/YEL WIRE
GRY WIRE
HEATED OXYGEN SENSOR (BANK 1, SENSOR 2) (FRONT OF EXHAUST) SL
HOT AT ALL TIMES
J/C 10 (BEHIND CENTER OF DASH)
J/C 12 (BEHIND RIGHT SIDE OF DASH)
J/C 12 (W/ CRUISE CONTROL) (BEHIND RIGHT SIDE OF DASH)
J/C 13 (RIGHT KICK PANEL)
J/C 9 (BEHIND CENTER OF DASH)
NCA WIRE
RED WIRE
RED/GRN WIRE
RED/WHT WIRE
RED/YEL WIRE
STOP FUSE
STOPLIGHT SWITCH (ON BRACKET, ABOVE BRAKE PEDAL)
TRANSFER CASE)
TRANSFER DETECTION SWITCH
TRANSFER DETECTION SWITCH (NEUTRAL) (TRANSFER CASE)
VEHICLE SPEED SENSOR (A/T) (ON TRANS)
VSV (EVAP) (REAR OF ENGINE)
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
WHT/RED WIRE
YEL WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> Wiring diagram engine performance 3.4ls (2 of 3) -> TRANSFER DETECTION SWITCH
