Toyota Tundra I (2000-2002) igniter igniter wiring diagram
This page shows the only wiring diagram for the component.igniter igniter, which is found in the car Toyota Tundra I (2000-2002). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
igniter igniter wiring diagram (1 of 1)
3.4L
4.7L
ADD ACTUATOR
BLK WIRE
BLOWER RESISTOR
BRN WIRE
CENTER AIR BAG SENSOR ASSEMBLY
COMBI- NATION METER
CONTROL ECU
CRUISE CONTROL ACTUATOR
CRUISE CONTROL ECU
CRUISE CONTROL SWITCH
DATA LINK CONNECTOR 3
DETECTION SWITCH (TRANSFER
DETECTION SWITCH (TRANSFER NEUTRAL POSITION)
ENGINE CONTROL MODULE
FROM J/C 13 (DIAGRAM 1 OF 2)
FUEL SENDER
HEATED OXYGEN SENSOR (BANK 1, SENSOR 1) HEATED OXYGEN SENSOR (BANK 1, SENSOR 2)
HEATED OXYGEN SENSOR BANK 1 SENSOR 2
HEATED OXYGEN SENSOR BANK 2 SENSOR 1
HEATED OXYGEN SENSOR BANK 2 SENSOR 2
IGNITER
IGNITER IGNITER
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3 IGNITION COIL 4
IGNITION COIL 5
IGNITION COIL 6
IGNITION COIL 8 IGNITION COIL 7
INTE- GRATION CONTROL, PANEL
INTE- GRATION RELAY
J/C 12 (UPPER RIGHT SIDE OF DASH)
J/C 8 (RIGHT OF STEERING COLUMN)
MAIN DAYTIME RUNNING LIGHT RELAY
NOISE FILTER
POSITION
POWER OUTLET
RADIO, PLAYER
RIGHT REAR LOWER DOOR COURTESY SWITCH
RIGHT REAR UPPER DOOR COURTESY SWITCH
SEAT BELT WARNING OCCUPANT DETECTION SENSOR
TRANSFER SHIFT ACTUATOR
TRANSMISSION CONTROL RELAY
WHT WIRE
WHT/BLK WIRE
Go to component -> Ground distribution circuit (2 of 2) -> IGNITER IGNITER
