Toyota Tacoma II facelift (2011-2015) add actuator assembly wiring diagram
This page shows the only wiring diagram for the component.add actuator assembly, which is found in the car Toyota Tacoma II facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
add actuator assembly wiring diagram (1 of 1)
4.0L
4.0L 2.7L
ADD ACTUATOR ASSEMBLY
ADD TRANSFER ACTUATOR INDICATOR ASSEMBLY SWITCH
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
AIR FUEL RATIO SENSOR (BANK 2 SENSOR 1) SHIELD
AIR SWITCHING AIR VALVE SWITCHING (BANK 2) VALVE
AIR SWITCHING VALVE
AIR SWITCHING VALVE (BANK 1)
AIR SWITCHING VALVE (BANK 2)
BLK WIRE
BRN WIRE
CAMSHAFT POSITION SENSOR SHIELD
CANISTER PUMP MODULE
CRANK- SHAFT POSITION SENSOR SHIELD
CRANKSHAFT POSITION SENSOR SHIELD
DATA LINK CONNECTOR 3
EE (4.0L)
EE (4.0L) (RIGHT REAR OF ENGINE COMPT)
EF (4.0L)
EF (4.0L) (LEFT REAR OF ENGINE COMPT)
EG (2.7L)
EG (2.7L) (REAR OF CYLINDER HEAD)
EH (2.7L)
EH (2.7L) (REAR OF CYLINDER HEAD)
ENGINE CONTROL MODULE
FROM INSTRUMENT PANEL J/B 2 (DIAGRAM 1 OF 4)
HEATED OXYGEN SENSOR (BANK 1 SENSOR 2) SHIELD
HEATED OXYGEN SENSOR (BANK 2 SENSOR 2) SHIELD
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
IGNITION COIL 5
IGNITION COIL 6
IGNITION IGNITION COIL 1 COIL 2
INSTRUMENT PANEL J/B 2
INSTRUMENT PANEL J/B 2 (RIGHT SIDE OF DASH)
JUNCTION CONNECTOR 12
JUNCTION CONNECTOR 12 (BEHIND RIGHT SIDE OF DASH)
KNOCK CONTROL SENSOR (BANK 1) SHIELD
KNOCK CONTROL SENSOR (BANK 2) SHIELD
NCA WIRE
NOISE FILTER (IGNITION)
SPIRAL CABLE
TO GROUND EE (DIAGRAM 1 OF 4)
TRANSFER INDICATOR SWITCH
TRANSFER SHIFT ACTUATOR ASSEMBLY
TRANSFER SHIFT CANISTER ACTUATOR PUMP ASSEMBLY MODULE
W/ CRUISE CONTROL
WHT WIRE
WHT/BLK WIRE
Go to component -> Ground distribution circuit (1 of 4) -> ADD ACTUATOR ASSEMBLY
