Toyota Tacoma II facelift (2011-2015) 3 10 4 tc sil tach wiring diagram
This page shows the only wiring diagram for the component.3 10 4 tc sil tach, which is found in the car Toyota Tacoma II facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
3 10 4 tc sil tach wiring diagram (1 of 1)
16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 BAT
16 22 13 SIL CANL CANH
3 10 4 TC SIL TACH
4.0L
7 8 CANL CANH COMBINATION METER
A/C AMPLIFIER (RIGHT SIDE OF DASH)
AIR BAG SENSOR ASSEMBLY CENTER (CENTER OF DASH)
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BLU/WHT WIRE
BLU/YEL WIRE
CANL TC TS
COMBINATION METER
DATA LINK CONNECTOR 3
DATA LINK CONNECTOR 3 (BELOW LEFT CENTER OF DASH)
DIA
EE (4.0L) (RIGHT REAR OF ENGINE COMPT) EH (2.7L) (REAR OF CYLINDER HEAD)
EE (4.0L) EH (2.7L)
ENGINE CONTROL MODULE
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
ENGINE ROOM R/B
ENGINE ROOM R/B (LEFT FRONT OF ENGINE COMPT)
GRN WIRE
HOT AT ALL TIMES
IC (CENTER OF DASH)
IGN
INSTRUMENT PANEL J/B 1
INSTRUMENT PANEL J/B 1 (LEFT SIDE OF DASH)
INSTRUMENT PANEL J/B 2
INSTRUMENT PANEL J/B 2 (RIGHT SIDE OF DASH)
J/C 18 (REAR OF ENGINE)
J/C 19
J/C 19 (LEFT END OF DASH)
J/C 4, 5
J/C 4, 5 (BEHIND RIGHT SIDE OF DASH)
JC-18
OBD FUSE
OCCUPANT CLASSIFICATION ECU
OCCUPANT CLASSIFICATION ECU (FRONT PASSENGER'S SEAT BOTTOM)
ORG/ WIRE
RED/BLK WIRE
SIL
SIL CANH SG CG
SKID CONTROL ECU W/ ACTUATOR
STEERING SENSOR
STEERING SENSOR (STEERING WHEEL)
STEERING WHEEL)
TAC
TACH
TIRE PRESSURE WARNING ECU
TRANSPONDER KEY ECU (LEFT SIDE OF DASH)
W/ BENCH SEAT
W/ HYDRAULIC BOOSTER TYPE W/ VACUUM BOOSTER TYPE
W/ SEPARATE SEAT
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YAW RATE SENSOR
YAW RATE SENSOR (UNDER PASSENGER SEAT)
YEL WIRE
YEL/BLK WIRE
Go to component -> Computer data lines circuit -> 3 10 4 TC SIL TACH
