Toyota Tacoma II (2004-2011) transfer shift canister actuator pump assembly module wiring diagram
This page shows the only wiring diagram for the component.transfer shift canister actuator pump assembly module, which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transfer shift canister actuator pump assembly module wiring diagram (1 of 1)
4.0L 2.7L
ADD TRANSFER ACTUATOR INDICATOR ASSEMBLY SWITCH
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
AIR FUEL RATIO SENSOR (BANK 2 SENSOR 1) SHIELD
BLK WIRE
BRN WIRE
CAMSHAFT, CRANKSHAFT SENSOR SHIELD
CRANK- SHAFT POSITION SENSOR SHIELD
DATA LINK CONNECTOR 3
EE (4.0L) (RIGHT REAR OF ENGINE COMPT)
EE (RIGHT REAR OF ENGINE COMPT)
EF (4.0L) (LEFT REAR OF ENGINE COMPT)
EG (2.7L) (REAR OF CYLINDER HEAD)
EH (2.7L) (REAR OF CYLINDER HEAD)
ENGINE CONTROL MODULE
HEATED OXYGEN SENSOR (BANK 1 SENSOR 2) SHIELD
HEATED OXYGEN SENSOR (BANK 2 SENSOR 2) SHIELD
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
IGNITION COIL 5
IGNITION COIL 6
IGNITION IGNITION COIL 1 COIL 2
INSTRUMENT PANEL J/B 2 (RIGHT SIDE OF DASH)
JUNCTION CONNECTOR 12 (RIGHT SIDE OF DASH)
KNOCK CONTROL SENSOR (BANK 1) SHIELD
KNOCK CONTROL SENSOR (BANK 2) SHIELD
NOISE FILTER (IGNITION)
TRANSFER INDICATOR SWITCH
TRANSFER SHIFT CANISTER ACTUATOR PUMP ASSEMBLY MODULE
W/ ADD
WHT WIRE
Go to component -> Ground distribution circuit (1 of 4) -> TRANSFER SHIFT CANISTER ACTUATOR PUMP ASSEMBLY MODULE
