Toyota Tacoma II (2004-2011) transfer shift actuator assembly (transmission assembly) wiring diagram
This page shows the only wiring diagram for the component.transfer shift actuator assembly (transmission assembly), which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
transfer shift actuator assembly (transmission assembly) wiring diagram (1 of 1)
2-4 SPD
4.0L
A/T M/T
ADD
BLK/WHT WIRE
BLU WIRE
BLU/BLK WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BRN/WHT WIRE
CONTROL SWITCH
DIFFERENTIAL LOCK SWITCH (LEFT SIDE OF DASH)
DRIVER SIDE J/B (LEFT SIDE OF DASH)
ECU (RIGHT SIDE OF DASH)
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
FUSE
GRN WIRE
GRY WIRE
GRY/BLK WIRE
HOT IN RUN OR START
IC (CENTER OF DASH)
IG GND
INSTRUMENT PANEL J/B 1 (LEFT SIDE OF DASH)
INSTRUMENT PANEL J/B 2 (RIGHT SIDE OF DASH)
J/C 13 (BEHIND RIGHT KICK PANEL)
J/C 14 (BEHIND RIGHT KICK PANEL)
J/C 5 (RIGHT SIDE OF DASH)
LIMIT SWITCH
LT GRN WIRE
LT GRN/BLK WIRE
LT GRN/RED WIRE
LT GRN/YEL WIRE
MTN
N/A N/A
PNK WIRE
PNK/BLU WIRE
RED WIRE
RED/BLK WIRE
RED/BLU WIRE
RLP
TRANSFER INDICATOR SWITCH (TRANSMISSION ASSEMBLY)
TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSMISSION ASSEMBLY)
VIO WIRE
VIO/WHT WIRE
WHT/BLK WIRE
YEL/BLK WIRE
Go to component -> 4wd circuit (1 of 2) -> TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSMISSION ASSEMBLY)
