Toyota Tacoma II (2004-2011) pressure combination warning meter ecu wiring diagram
This page shows the only wiring diagram for the component.pressure combination warning meter ecu, which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
pressure combination warning meter ecu wiring diagram (1 of 1)
ACCESSORY METER
AIR BAG SENSOR ASSEMBLY CENTER
BA (UNDER DRIVER'S SEAT)
BD (LEFT REAR FRAME RAIL)
BE (LEFT "B" PILLAR)
BLK WIRE
BODY
CENTER ROOM LAMP
CIGARETTE LIGHTER
DATALINK CONNECTOR
DIFFERENTIAL LOCK SHIFT ACTUATOR ASSEMBLY
DRIVER SIDE J/B (LEFT SIDE OF DASH)
DRIVER'S SIDE FRONT SEAT INNER BELT
DRIVER'S SIDE OUTER WINDOW DOOR MIRROR MASTER LOCK SWITCH SWITCH ASSEMBLY
FUEL SUCTION RIGHT PUMP, REAR GAUGE COMBINATION ASSEMBLY LAMP
IA (LEFT KICK PANEL)
INNER REAR VIEW MIRROR
JUNCTION CONNECTOR 1
LEFT LICENSE PLATE LAMP
LEFT REAR COMBINATION LAMP
P/W RELAY
POWER
POWER POINT RHEOSTAT SOCKET
PRESSURE COMBINATION WARNING METER ECU
REAR DIFFERENTIAL TRANSFER INDICATOR SWITCH
RIGHT (IF LICENSE EQUIPPED) PLATE TRAILER LAMP SOCKET
SKT RELAY
TIRE TOWING BRAKE CONTROLLER
TO GROUND IC (DIAGRAM 4 OF 4)
TURN SIGNAL FLASHER
UNLOCK COMBINATION WARNING SWITCH SWITCH
WHT WIRE
Go to component -> Ground distribution circuit (3 of 4) -> PRESSURE COMBINATION WARNING METER ECU
