Toyota Tacoma II (2004-2011) hydraulic booster type wiring diagram
This page shows the only wiring diagram for the component.hydraulic booster type, which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
hydraulic booster type wiring diagram (1 of 1)
A/F HEATER RELAY
BATT CHG RELAY
BLK WIRE
BRAKE FLUID LEVEL WARNING SWITCH
COMBINATION SWITCH
CONTROL SWITCH
EA (RIGHT FRONT FENDER)
EB (2.7L: LEFT FRONT OF ENGINE COMPT) (4.0L: NEAR BATTERY)
EFI RELAY
ENGINE ROOM J/B (LEFT SIDE OF ENGINE COMPT)
ENGINE ROOM R/B (LEFT FRONT OF ENGINE COMPT)
FOG TRANSPONDER RSCA LAMP KEY OFF SWITCH ECU SWITCH
FROM UNLOCK WARNING SWITCH (DIAGRAM 3 OF 4)
HEATER RELAY
HYDRAULIC BOOSTER TYPE
IC (CENTER OF DASH)
JUNCTION CONNECTOR 4, 5 (RIGHT SIDE OF DASH)
LEFT FRONT FOG RIGHT HEADLAMP LAMP
LEFT FRONT TURN SIGNAL LAMP
LEFT HEADLAMP
LEFT PARKING LAMP
RIGHT FRONT FOG LAMP
RIGHT FRONT TURN PRESSURE SWITCH
RIGHT PARKING SIGNAL LAMP LAMP
SKID CONTROL ECU W/ ACTUATOR
STA RELAY
TIRE PRESSURE WARNING RESET SWITCH
VACUUM BOOSTER TYPE
W/ DAYTIME RUNNING LIGHT
W/ DRL
W/ VACUUM BOOSTER TYPE) SKID CONTROL ECU W/ ACTUATOR
WHT WIRE
WHT/BLK WIRE
WINDSHIELD WIPER MOTOR
WIRELESS DOOR LOCK BUZZER
Go to component -> Ground distribution circuit (4 of 4) -> HYDRAULIC BOOSTER TYPE
