Toyota Tacoma II (2004-2011) booster type pnk ig+ se si wiring diagram
This page shows the only wiring diagram for the component.booster type pnk ig+ se si, which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
booster type pnk ig+ se si wiring diagram (1 of 1)
9 10 11 12 GND SIL
A/T M/T
BLK/WHT WIRE
BLU WIRE
BLU/WHT WIRE
BOOSTER TYPE PNK IG+ SE SI WIRE
CLSW SPD TC TACH IND
COMBINATION METER
COMPUTER DATA LINES SYSTEM
CONTROL
DRIVER SIDE J/B (LEFT SIDE
ECU-B FUSE
ENGINE 4.0L 2.7L CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
ENGINE ROOM R/B (LEFT FRONT OF ENGINE COMPT)
GAUGE FUSE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IG 1 FUSE OF DASH) FUSE
J/C 4, 5 (RIGHT SIDE OF DASH)
LT GRN WIRE
PNK WIRE
PNK/BLK WIRE
PRESSURE
RED WIRE
RED/WHT WIRE
RED/YEL WIRE
SPEED CONTROL
TACH
TIRE PRESSURE IND
TIRE PRESSURE MONITOR ECU (CENTER OF DASH)
TIRE PRESSURE WARNING RESET SWITCH
TIRE)
VEHICLE SPEED SENSOR (COMBINATION METER) (M/T) (TRANSMISSION)
VIO WIRE
VIO/WHT WIRE
W/ VACCUM BOOSTER TYPE W/ HYDRAULIC
WHT WIRE
WHT/BLK WIRE
WHT/GRN WIRE
Go to component -> Tire pressure monitoring circuit -> BOOSTER TYPE PNK IG+ SE SI WIRE
