Toyota Tacoma II (2004-2011) body ecu (on j/b 1) wiring diagram
This page shows the only wiring diagram for the component.body ecu (on j/b 1), which is found in the car Toyota Tacoma II (2004-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
body ecu (on j/b 1) wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 PNK IG TFR LR TFL LL WIRE
5 13 DRL TAIL
BLK/YEL WIRE
BLU/BLK WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BODY ECU (ON J/B 1)
CANADA
COMBINATION METER
COMBINATION SWITCH
DRIVER SIDE J/B (LEFT SIDE OF DASH)
DRL
EA (AT RIGHT FRONT FENDER)
EB (2.7L: LEFT FRONT OF ENGINE COMPT) (4.0L: NEAR BATTERY)
EL ER
ENGINE ROOM J/B (LEFT SIDE OF ENGINE COMPT)
ENGINE ROOM R/B (LEFT FRONT OF ENGINE COMPT)
FUSE
GRN WIRE
HAZARD WARNING HAZARD SIGNAL SWITCH SWITCH ASSEMBLY
HEAD
HOT AT ALL TIMES
HOT IN ON OR START
IC (CENTER OF DASH)
J/C 1 (BEHIND LEFT SIDE OF DASH)
J/C 13 (BEHIND RIGHT KICK PANEL)
J/C 4, 5 (RIGHT SIDE OF DASH)
LEFT
LEFT FRONT TURN SIGNAL LAMP
LEFT TURN IND
LIGHT CONTROL SWITCH
LT BLU WIRE
LT GRN WIRE
LT GRN/BLK WIRE
LT GRN/RED WIRE
OFF
PNK WIRE
RED/BLK WIRE
RED/WHT WIRE
RED/YEL WIRE
RIGHT
RIGHT FRONT TURN SIGNAL LAMP
RIGHT TURN IND
SHORT PIN
TAIL
TAIL IND (CANADA)
TRN-HAZ FUSE
TURN SIGNAL FLASHER (LEFT SIDE OF DASH)
TURN SIGNAL SWITCH
W/ DRL
W/O DRL
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Exterior lamps circuit, without trailer tow (2 of 2) -> BODY ECU (ON J/B 1)
