Toyota Sienna III (2010-2014) seat control receiver wiring diagram
This page shows the only wiring diagram for the component.seat control receiver, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
seat control receiver wiring diagram (1 of 1)
AWD ECU ASSEMBLY
BACK DOOR OPENER SWITCH ASSEMBLY
BLK WIRE
CENTER STOP LIGHT ASSEMBLY
DOOR CONTROL SWITCH ASSEMBLY (POWER BACK DOOR)
FUEL PUMP
LEFT "C" PILLAR)
LEFT DOOR CONTROL RELAY
LEFT FOLD SEAT CONTROL ECU
LEFT FOLDING MOTOR
LEFT FRONT SEAT ASSEMBLY
LEFT LICENSE PLATE LIGHT ASSEMBLY
LEFT POSITION CONTROL ECU, SWITCH ASSEMBLY
LEFT POWER OPEN SLIDE STOP LOCK DOOR LOCK ASSEMBLY ASSEMBLY
LEFT POWER SLIDE DOOR CONTROL SWITCH 1
LEFT REAR COMBINATION LIGHT ASSEMBLY
LEFT REAR LIGHT ASSEMBLY
LEFT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
LEFT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
LEFT SEAT HEATER CONTROL SUB-ASSEMBLY
LEFT SLIDE DOOR FULL
LEFT SLIDE DOOR HANDLE ASSEMBLY
POWER BACK DOOR UNIT ASSEMBLY
POWER BACK DOOR WARNING BUZZER
REAR WINDOW DEFOGGER (BACK DOOR GLASS)
REAR WIPER, MOTOR, BRACKET ASSEMBLY
RIGHT FOLD SEAT CONTROL ECU
RIGHT FOLDING MOTOR
RIGHT LICENSE PLATE LIGHT ASSEMBLY
RIGHT REAR LIGHT ASSEMBLY
SEAT CONTROL RECEIVER
W/ SEAT HEATER
W/ SMART KEY SYSTEM W/O SMART KEY SYSTEM W/ MEMORY
W/O MEMORY
W/O SEAT HEATER
WHT WIRE
WHT/BLK WIRE
Go to component -> Ground distribution circuit (6 of 6) -> SEAT CONTROL RECEIVER
