Toyota Sienna III (2010-2014) mswe cann canp wiring diagram
This page shows the only wiring diagram for the component.mswe cann canp, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
mswe cann canp wiring diagram (1 of 1)
1 2 3 13 8 9 MM
BLK WIRE
BLU WIRE
BRN WIRE
BUCKLE SWITCH
COMPUTER DATA LINES SYSTEM
ECU-B FUSE
ENGINE ROOM R/B
GRN WIRE
GRY WIRE
HOLD
HOT AT ALL TIMES
INSTRUMENT PANEL J/B (LEFT SIDE OF DASH)
LEFT FRONT LUMBAR SUPPORT FORWARD, BACK
LEFT FRONT POWER SEAT LIFT POSITION MOTOR ASSEMBLY (BASE OF LEFT FRONT SEAT)
LEFT FRONT POWER SEAT SLIDE POSITION MOTOR ASSEMBLY (LEFT FRONT SEAT ASSEMBLY)
LEFT FRONT POWER SEAT SWITCH ASSEMBLY (LEFT FRONT
LEFT FRONT POWER SEAT VERTICAL POSITION MOTOR ASSEMBLY (BASE OF LEFT FRONT SEAT)
LEFT FRONT SEAT ASSEMBLY
LEFT OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER'S DOOR)
LEFT POSITION CONTROL ECU, SWITCH ASSEMBLY (LEFT FRONT SEAT ASSEMBLY)
LT BLU WIRE
LT GRN WIRE
LUMBAR SUPPORT
MOTOR ASSEMBLY (BASE OF LEFT FRONT SEAT)
MRY SET
MSWE CANN CANP
P/SEAT F/L FUSE
PNK WIRE
RED WIRE
RELEASE
SEAT ASSEMBLY)
SEAT MEMORY SWITCH
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Memory seat circuit -> MSWE CANN CANP
