Toyota Sienna III (2010-2014) distance control wiring diagram
This page shows the only wiring diagram for the component.distance control, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
distance control wiring diagram (1 of 1)
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BLU/BLK WIRE
BRN WIRE
BUZZER
CANCEL SET-
COMBINATION METER
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL SWITCH CRUISE CONTROL MAIN SWITCH
CRUISE IND
DISTANCE CONTROL
DRIVER IC
DYNAMIC RADAR
ECU- IG 1 FUSE
ECU-IG 2 FUSE
FUSE (LEFT SIDE OF ENGINE COMPT)
GAUGE 1 FUSE
GAUGE 2 FUSE
GRN WIRE
GRN/BLK WIRE
GRN/ORG WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INSTRUMENT PANEL J/B
LT GRN/RED WIRE
MICRO- PROCESSOR
MODE
ON OFF
PNK WIRE
POWER SUPPLY CIRCUIT
READY IND
RED WIRE
RELAY ENERGIZED
RIGHT STEERING SWITCH
SET IND
SPIRAL CABLE SUB-ASSEMBLY (LEFT SIDE OF DASH)
STEERING PAD SWITCH ASSEMBLY
STOP FUSE
VIO WIRE
WHT WIRE
WIP FUSE
Go to component -> 3.5l, dynamic laser cruise control circuit (2 of 3) -> DISTANCE CONTROL
