Toyota Sienna III (2010-2014) computer data lines system pnk wiring diagram
This page shows the only wiring diagram for the component.computer data lines system pnk, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
computer data lines system pnk wiring diagram (1 of 1)
29 30 CANL CANH
7 20 25 MGND ES LCL-
BLK WIRE
BLU WIRE
BRN WIRE
COMBINATION METER ASSEMBLY
COMPUTER DATA LINES SYSTEM PNK WIRE
FRONT WASHER SWITCH
FRONT WIPER SWITCH
GAUGE 2 FUSE
GRN WIRE
GRY WIRE
HOT IN ON OR START
HOT IN ON OR START INSTRUMENT PANEL J/B (LEFT SIDE OF DASH)
INTERMITTENT
LEVEL WARNING SWITCH ASSEMBLY (RIGHT FRONT OF ENGINE COMPT)
MICRO- PROCESSOR
MIST
MIST HI HI OFF LO LO INT INT
MIST HI OFF LO
OFF INT
PNK WIRE
POWER SUPPLY CIRCUIT
RED WIRE
WASHER FUSE
WASHER IND
WHT WIRE
WHT/BLK WIRE
WINDSHIELD WASHER MOTOR, PUMP ASSEMBLY (RIGHT FRONT OF ENGINE COMPT)
WINDSHIELD WIPER MOTOR ASSEMBLY (LEFT REAR OF ENGINE COMPT)
WINDSHIELD WIPER SWITCH ASSEMBLY
WIP FUSE
Go to component -> Front wiper/washer circuit, without auto wiper system -> COMPUTER DATA LINES SYSTEM PNK WIRE
