Toyota Sienna III (2010-2014) computer can+ can- data lines system wiring diagram
This page shows the only wiring diagram for the component.computer can+ can- data lines system, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
computer can+ can- data lines system wiring diagram (1 of 1)
+B BATT IGSW STP ST-
34 2 3 1 28 36 35 MREL
44 45 37 59 60 56 57 58 55 LGND CCS CCHG
ACCELERATOR POSITION SENSOR (ACCELERATOR PEDAL ASSEMBLY)
BLK WIRE
BLK/ORG WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU WIRE
BLU/YEL WIRE
BRN WIRE
COMPUTER CAN+ CAN- DATA LINES SYSTEM
ECM (LEFT REAR OF ENGINE COMPT)
ECT FUSE
ECU-B FUSE
EFI 1 FUSE
EFI MAIN RELAY
ENGINE CONTROLS SYSTEM
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
GRN/BLK WIRE
GRN/ORG WIRE
GRY/RED WIRE
HOT AT ALL TIMES
LT GRN WIRE
LT GRN/RED WIRE
M- M+ ETA
OUT
PARK/NEUTRAL POSITION SWITCH ASSEMBLY (TRANSAXLE ASSEMBLY)
PNK WIRE
RED WIRE
RED/BLK WIRE
STOP LP RELAY
THROTTLE W/ MOTOR BODY ASSEMBLY (INTAKE MANIFOLD ASSEMBLY)
TRANSMISSION CONTROL ECU ASSEMBLY
VCPA EPA VPA
VIO WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
YEL WIRE
Go to component -> 3.5l, dynamic laser cruise control circuit (1 of 3) -> COMPUTER CAN+ CAN- DATA LINES SYSTEM
