Toyota Sienna III (2010-2014) back door lock assembly (w/ power back door: wiring diagram
This page shows the only wiring diagram for the component.back door lock assembly (w/ power back door:, which is found in the car Toyota Sienna III (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
back door lock assembly (w/ power back door: wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 9 10 FLD+ RCL+ RACT B+ FLD- RCL-
4 7 +B
BACK DOOR LOCK ASSEMBLY (W/ POWER BACK DOOR:
BDCY
BLK WIRE
BLU WIRE
BRN WIRE
ECU-IG 2 FUSE
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
FOLD SEAT
FOLDING MOTOR
FRONT
FUSE
GRN WIRE
GRY WIRE
HALL IC SENSOR
HOT AT ALL TIMES
INSTRUMENT PANEL J/B (LEFT SIDE OF DASH)
LATCH RELEASE ACTUATOR
LCKR LCKF
LEFT FOLD POWER SEAT SWITCH ASSEMBLY
LEFT FOLDING MOTOR (UNDER LEFT SIDE OF REAR SEAT 2)
LEFT FOLDING SEAT CONTROL ECU (LOWER LEFT OF REAR SEAT 2)
LEFT FRONT SEAT LOCK SWITCH
LEFT REAR SEAT LOCK SWITCH
LT BLU WIRE
LT GRN WIRE
PNK RCLF RCLR TBL RTRN FOLD WIRE
PNK WIRE
REAR
RECLINING SWITCH
RED WIRE
RELAY ENERGIZED
RIGHT REAR SEAT LOCK SWITCH
RIGHT RETRACT FRONT LOCK SEAT LOCK SWITCH SWITCH
SRCL SFLD
STOP FUSE
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Third row folding seat circuit (1 of 2) -> BACK DOOR LOCK ASSEMBLY (W/ POWER BACK DOOR:
