Toyota Sienna II facelift (2005-2010) skid control ecu w/ actuator (at left rear of engine compartment) wiring diagram
This page shows the only wiring diagram for the component.skid control ecu w/ actuator (at left rear of engine compartment), which is found in the car Toyota Sienna II facelift (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
skid control ecu w/ actuator (at left rear of engine compartment) wiring diagram (1 of 1)
ABS 2 FUSE ABS 1 FUSE
ABS IND.
BLK WIRE
BLK/RED WIRE
BLK/YEL WIRE
BLU WIRE
BLU/WHT WIRE
BM FR+ FL- RR+ RL-
BRAKE IND
BRK RELAY
BRN WIRE
COMBINATION METER
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN)
ECU-IG FUSE
FUSIBLE LINK BLOCK (ON LEFT SIDE
GAUGE 2 FUSE
GRN WIRE
GRN/ORG WIRE
GRN/WHT WIRE
GRN/YEL WIRE
GRY/RED WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IF (BEHIND LOWER CENTER OF DASH)
IND
J/C 15 (BEHIND LEFT END OF DASH)
J/C 2 (AT LEFT SIDE OF ENGINE COMPT)
J/C 5, 6 (BEHIND LEFT END OF DASH)
J/C 7, 8 (BEHIND LEFT END OF DASH)
LEFT FRONT ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF LEFT FRONT WHEEL)
LEFT REAR ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF LEFT REAR WHEEL)
LT GRN WIRE
OF ENGINE COMPT, INSIDE ENGINE ROOM J/B)
ORG/ WIRE
PKB WA BZ +BS
PNK/BLU WIRE
RED WIRE
RED/BLU WIRE
RED/WHT WIRE
RIGHT FRONT ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF RIGHT FRONT WHEEL)
RIGHT REAR ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF RIGHT REAR WHEEL)
SKID CONTROL ECU W/ ACTUATOR (AT LEFT REAR OF ENGINE COMPARTMENT)
SLIP IND
SPEEDOMETER
TIRE PRESSURE
TRAC OFF IND
TS CANL
VIO/RED WIRE
VIO/YEL WIRE
VSC IND
W/ DYNAMIC LASER CRUISE CONTROL
W/O DYNAMIC LASER CRUISE CONTROL
WFSE CSW BRL R+
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
YEL WIRE
YEL/BLK WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> Anti-lock brakes circuit, with vsc (1 of 2) -> SKID CONTROL ECU W/ ACTUATOR (AT LEFT REAR OF ENGINE COMPARTMENT)
