Toyota Sienna II facelift (2005-2010) occupant classification ecu wiring diagram
This page shows the only wiring diagram for the component.occupant classification ecu, which is found in the car Toyota Sienna II facelift (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
occupant classification ecu wiring diagram (1 of 1)
10 3 2 1 FSR- FSR+
2 19 6 11 LBE- LBE+
AIR BAG AIR BAG SENSOR
ASSEMBLY (BELOW CENTER OF DASH)
BGND BSW FSR+ FSR-
BLK/RED WIRE
BLU WIRE
BLU/BLK WIRE
BODY ECU (BEHIND LEFT SIDE OF DASH)
BRN WIRE
BUZZER +B
COMBINATION METER
COMPUTER DATA LINES SYSTEM
DCTY
DOOR IND
DRIVE IC
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN)
ECU-ACC FUSE
ECU-B FUSE
ECU-IG FUSE
ENGINE ROOM J/B
GAUGE 2 FUSE
GRN/BLK WIRE
GRN/RED WIRE
GRN/WHT WIRE
GRN/YEL WIRE
HOT AT ALL TIMES
HOT IN ACC OR ON
HOT IN ON OR START
IC BEAN
IE (AT LEFT KICK PANEL)
IF (BEHIND LOWER CENTER OF DASH)
IG BECU
J/C 11, 12 (BEHIND LEFT END OF DASH)
J/C 18 (BEHIND UPPER LEFT SIDE OF DASH)
LEFT BUCKLE SWITCH (IN LEFT FRONT SEAT BELT BUCKLE ASSEMBLY)
LEFT FRONT DOOR COURTESY SWITCH (AT LEFT "B" PILLAR)
MICRO COMPUTER
OCCUPANT CLASSIFICATION ECU
POWER SUPPLY CIRCUIT
RED WIRE
RED/BLU WIRE
RED/YEL WIRE
RIGHT BUCKLE SWITCH (IN RIGHT FRONT SEAT BELT BUCKLE ASSEMBLY)
SEAT BELT IND
UNLOCK WARNING SWITCH (ON UPPER STEERING COLUMN)
VIO WIRE
W/ POWER SEAT
W/ SIDE AIR BAG W/O SIDE AIR BAG
WHT/BLK WIRE
WHT/BLU WIRE
Go to component -> Key reminder & seat belt warning circuit -> OCCUPANT CLASSIFICATION ECU
