Toyota Sienna II facelift (2005-2010) engine control module els wiring diagram
This page shows the only wiring diagram for the component.engine control module els, which is found in the car Toyota Sienna II facelift (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
engine control module els wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 PNK +B WIRE
AC INV FUSE
ACC CUT RELAY
BH (AT LEFT "B" PILLAR)
BLK WIRE
BLK/ORG WIRE
BLK/RED WIRE
BLK/YEL WIRE
BLU/ORG WIRE
BRN WIRE
BRN/RED WIRE
DEFOGGER SYSTEM
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN)
ENGINE CONTROL MODULE ELS
FOG FUSE
FOG RELAY
FR DEF FUSE
FROM DRIVER SIDE J/B (DIAGRAM 1 OF 3)
FROM ENGINE ROOM J/B (DIAGRAM 3 OF 3)
FROM FUSIBLE LINK BLOCK (DIAGRAM 1 OF 3)
FROM JUNCTION
FUSE
FUSE ST FUSE BOX (BEHIND LOWER RIGHT SIDE OF DASH)
GRN WIRE
IG (AT RIGHT KICK PANEL)
IGNITION SWITCH
INVERTER RELAY (BEHIND UPPER LEFT SIDE OF DASH)
JUNCTION CONNECTOR 20 (BEHIND UPPER
JUNCTION CONNECTOR 3, 4 (BEHIND LEFT END OF DASH)
LOCK
LOCK OFF
MAIN SWITCH
MEMORY SYSTEMS COMPUTER DATA LINES SYSTEM
OBD FUSE
ON OFF
P/W FUSE S/ROOF FUSE P/SEAT FUSE
PNK WIRE
POWER OUTLET 1
POWER OUTLET 2
POWER TOPS SEATS SYSTEM SYSTEM
POWER WINDOWS, MEMORY SYSTEMS
RED BRN/ WIRE
RED WIRE
RED/BLU WIRE
SFT FUSE BOX 2 (RIGHT SIDE OF DASH)
SHIFT INTERLOCK SYSTEM
STARTING/ CHARGING, ENGINE CONTROLS, TRANSMISSIONS SYSTEMS
STOP FUSE
TO DRIVER SIDE J/B (DIAGRAM 1 OF 3)
TO DRIVER SIDE J/B (DIAGRAM 3 OF 3)
VIO WIRE
VOLTAGE INVERTER (ABOVE LEFT REAR WHEELWELL)
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
Go to component -> Power distribution circuit (2 of 3) -> ENGINE CONTROL MODULE ELS
