Toyota Sienna II facelift (2005-2010) driver seat lumbar support control power seat control switch wiring diagram
This page shows the only wiring diagram for the component.driver seat lumbar support control power seat control switch, which is found in the car Toyota Sienna II facelift (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
driver seat lumbar support control power seat control switch wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 PMVR LP
BDR
BH (AT LEFT "B" PILLAR)
BLK/RED WIRE
BLU WIRE
BLU/BLK WIRE
BLU/YEL WIRE
COMPUTER DATA LINES SYSTEM
CTRL CIRCUIT
CTYB PVC VSSR
CYL HSSR
DRIVER SEAT LUMBAR SUPPORT CONTROL POWER SEAT CONTROL SWITCH
FRV-
GRN WIRE
GRY WIRE
IG (AT RIGHT KICK PANEL)
J/C 44, 45 (UNDER LEFT FRONT SEAT)
LEFT OUTER REAR VIEW MIRROR
LFT-
LT GRN WIRE
ORG/ WIRE
PNK PMHR PM+R WIRE
PNK WIRE
POSITION CONTROL ECU, SWITCH
RCL-
RED WIRE
RED/BLK WIRE
RED/BLU WIRE
RED/GRN WIRE
RIGHT OUTER MIRROR CONTROL ECU (IN RIGHT FRONT DOOR)
RIGHT OUTER REAR VIEW MIRROR
SIG CPUB
SLD
SYSB
VIO WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YEL WIRE
YEL/GRN WIRE
Go to component -> Memory systems circuit (2 of 2) -> DRIVER SEAT LUMBAR SUPPORT CONTROL POWER SEAT CONTROL SWITCH
