Toyota Sienna II (2003-2005) turbine speed sensor (at rear of transaxle) wiring diagram

+BM 17 18 29 24 10 19 12 6 SPD 28 18 17 3 2 29 19 1 4 7 PNK CCHG LGND WIRE 6 7 8 9 PNK WIRE 8 1 2 MREL +B ACCEL POSITION SENSOR (UNDER LEFT SIDE OF DASH) BLK WIRE BLK/ORG WIRE BLK/RED WIRE BLK/WHT WIRE BLU WIRE BLU/WHT WIRE BLU/YEL WIRE BRN WIRE CANL CANH COMPUTER DATA LINES SYSTEM DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN) EB (AT FRONT OF ENGINE) COUNTER GEAR SPEED SENSOR (ON TOP OF TRANSAXLE) EC (AT REAR OF ENGINE) ECU W/ ACTUATOR 10 9 8 23 22 12 25 11 NEO ENG+ TRC+ ENG- TRC- PNK WIRE ECU-B FUSE ED (AT LEFT SIDE OF ENGINE COMPT) EFI 1 FUSE EFI RELAY END OF DASH) ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH) ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPT) ETCS FUSE GAUGE 1 FUSE GAUGE 2 FUSE GRN/RED WIRE GRN/WHT WIRE GRY WIRE GRY/RED WIRE HOT AT ALL TIMES HOT IN ON OR START J/B 3, 4 (BEHIND LEFT J/C 18 (BEHIND UPPER LEFT SIDE OF DASH) J/C 19 (BEHIND UPPER LEFT SIDE OF DASH) J/C 2 (AT LEFT SIDE OF ENGINE COMPT) J/C 20 (BEHIND UPPER LEFT CENTER OF DASH) J/C 20 (BEHIND UPPER LEFT SIDE OF DASH) J/C 21 (BEHIND UPPER LEFT CENTER OF DASH) J/C 29 (BEHIND RIGHT SIDE OF DASH) J/C 3, 4 (BEHIND LEFT END OF DASH) J/C 5, 6 (BEHIND LEFT END OF DASH) LT GRN WIRE LT GRN/BLK WIRE LT GRN/RED WIRE M+ M- ELC LCS NCA WIRE NT+ NT- NC+ NC- PARK/ NEUTRAL POSITION SWITCH (ON TRANSAXLE) PNK WIRE PNK/BLK WIRE RED WIRE RED/BLK WIRE RED/BLU WIRE THROTTLE CONTROL MOTOR, THROTTLE POSITION SENSOR TURBINE SPEED SENSOR (AT REAR OF TRANSAXLE) VIO WIRE VIO/WHT WIRE WHT WIRE WHT/BLK WIRE WHT/BLU WIRE WHT/GRN WIRE WHT/RED WIRE YEL WIRE