Toyota Sienna II (2003-2005) of engine compt, inside engine room j/b) wiring diagram

ABS 2 FUSE ABS 1 FUSE ABS IND. BLK WIRE BLK/RED WIRE BLK/YEL WIRE BLU WIRE BLU/ORG WIRE BLU/WHT WIRE BM FR+ FL- RR+ RL- BRAKE IND BRK RELAY BRN WIRE COMBINATION METER D/G MRF MR STPO FR- FL+ RR- RL+ DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN) DRIVER SIDE J/B STOP FUSE (BEHIND DASH, LEFT OF STEERING COLUMN) ECU-IG FUSE FUSIBLE LINK BLOCK (ON LEFT SIDE GAUGE 2 FUSE GRN WIRE GRN/ORG WIRE GRN/RED WIRE GRN/WHT WIRE GRN/YEL WIRE GRY WIRE GRY/BLU WIRE GRY/RED WIRE HOT AT ALL TIMES HOT IN ON OR START IF (BEHIND LOWER CENTER OF DASH) IND INIT WFSE CSW BRL R+ J/C 15 (BEHIND LEFT END OF DASH) J/C 2 (AT LEFT SIDE OF ENGINE COMPT) J/C 5, 6 (BEHIND LEFT END OF DASH) J/C 7, 8 (BEHIND LEFT END OF DASH) LEFT FRONT ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF LEFT FRONT WHEEL) LEFT REAR ABS SPEED SENSOR LT GRN WIRE LT GRN/BLK WIRE LT GRN/RED WIRE OF ENGINE COMPT, INSIDE ENGINE ROOM J/B) ORG/ WIRE PKB WA BZ +BS PNK WIRE PNK/BLU WIRE PNK/GRN WIRE RED WIRE RED/BLU WIRE RED/WHT WIRE RIGHT FRONT ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF RIGHT FRONT WHEEL) RIGHT REAR ABS SPEED SENSOR (MOUNTED ON HUB ASSEMBLY OF RIGHT REAR WHEEL) SKID CONTROL ECU W/ ACTUATOR (AT RIGHT SIDE OF ENGINE COMPT) SLIP IND SPEEDOMETER STOPLIGHT SWITCH (ON BRACKET, ABOVE BRAKE PEDAL) TIRE PRESSURE TRAC OFF IND TRC+ ENG+ NEO CANH TRC- ENG- TS CANL WTIR VIO WIRE VIO/RED WIRE VIO/YEL WIRE VSC IND VSCW W/ DYNAMIC LASER CRUISE CONTROL W/O DYNAMIC LASER CRUISE CONTROL WHT WIRE WHT/BLK WIRE WHT/BLU WIRE WHT/RED WIRE YEL WIRE YEL/BLK WIRE YEL/GRN WIRE YEL/RED WIRE