Toyota Sienna II (2003-2005) normal ind wiring diagram
This page shows the only wiring diagram for the component.normal ind, which is found in the car Toyota Sienna II (2003-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
normal ind wiring diagram (1 of 1)
1 2 3 4 5 LGND SGND LRDD LRRD IGB
6 7 8 9 PNK WIRE
BLK WIRE
BLK/ORG WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU WIRE
BLU/ORG WIRE
BLU/YEL WIRE
BRN WIRE
BUZZER
COMBINATION METER
COMBINATION SWITCH DIST
COMPUTER DATA LINES SYSTEM
CRUISE CHECK IND
CRUISE IND
DISTANCE CONTROL ECU (BEHIND RIGHT SIDE OF DASH)
DISTANCE CONTROL SWITCH
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN)
ECU-IG FUSE
GND IGB
GRN WIRE
GRN/WHT WIRE
GRY WIRE
GRY/RED WIRE
HOT AT ALL TIMES
IGN FUSE
J/C 15 (BEHIND LEFT END OF DASH)
J/C 18 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 28 (BEHIND RIGHT SIDE OF DASH)
J/C 3, 4 (BEHIND LEFT END OF DASH)
J/C 5, 6 (BEHIND LEFT END OF DASH)
LASER RADAR SENSOR (BEHIND RIGHT SIDE OF FRONT BUMPER)
LRDD LRRD ELC LCS
LT GRN/RED WIRE
MODE
NORMAL IND
ORG/ WIRE
PNK WIRE
R/N
READY IND
RED WIRE
RED/BLU WIRE
SGND
SPEEDOMETER
STOP FUSE
STOP LIGHT SWITCH (ON BRACKET, ABOVE BRAKE PEDAL)
VIO WIRE
VIO/WHT WIRE
WASH
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
YEL WIRE
Go to component -> Dynamic laser cruise control circuit (2 of 2) -> NORMAL IND
