Toyota Sienna II (2003-2005) headlight beam level control actuator rh (behind right headlight) wiring diagram
This page shows the only wiring diagram for the component.headlight beam level control actuator rh (behind right headlight), which is found in the car Toyota Sienna II (2003-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
headlight beam level control actuator rh (behind right headlight) wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
EA (FRONT SIDE OF THE RIGHT FENDER APRON)
ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMP)
GRN WIRE
GRN/BLK WIRE
H-LP (LL) FUSE
HEADLIGHT BEAM LEVEL CONTROL ACTUATOR LH (BEHIND LEFT HEADLIGHT)
HEADLIGHT BEAM LEVEL CONTROL ACTUATOR RH (BEHIND RIGHT HEADLIGHT)
HEADLIGHT BEAM LEVEL CONTROL SWITCH
HOT W/ HEADLIGHT RELAY ENERGIZED
IG RIGHT KICK PANEL)
J/C 1 (LEFT SIDE OF ENGINE COMPARTMENT)
J/C 2 (LEFT SIDE OF ENGINE COMPARTMENT)
J/C 20 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 27 (BEHIND RIGHT SIDE OF DASH)
J/C 5,6 (BEHIND LEFT END OF DASH)
RED WIRE
WHT WIRE
WHT/BLK WIRE
Go to component -> Headlamps leveling circuit -> HEADLIGHT BEAM LEVEL CONTROL ACTUATOR RH (BEHIND RIGHT HEADLIGHT)
