Toyota Sienna II (2003-2005) door ecu wiring diagram
This page shows the only wiring diagram for the component.door ecu, which is found in the car Toyota Sienna II (2003-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
door ecu wiring diagram (1 of 1)
10 9 CANH CANL
11 8 D/G TC WFSE TS CANL CANH
16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 BAT WFSE CANL TC TS
19 20 18 WFSE TC SIL
2 3 CANL CANH
A/C CONTROL ASSEMBLY
AIR BAG SENSOR ASSEMBLY
BLK WIRE
BLK/ORG WIRE
BLU WIRE
BODY ECU
BRN WIRE
COMBINATION METER
DATA LINK CONNECTOR 3 (BELOW LEFT SIDE OF DASH)
DOOR ECU
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN)
DRIVER SIDE J/B (BEHIND DASH, LEFT OF STEERING COLUMN) OBD FUSE
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
GRY/RED WIRE
HOT AT ALL TIMES
J/C 13, 14 (BEHIND LEFT END OF DASH)
J/C 17 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 18 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 19 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 20 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 29 (BEHIND RIGHT SIDE OF DASH)
J/C 31, 32 (BEHIND RIGHT SIDE OF DASH)
J/C 35, 36 (BEHIND RIGHT SIDE OF DASH)
J/C 37 (FORWARD OF LEFT REAR WHEELWELL)
J/C 5, 6 (BEHIND LEFT END OF DASH)
J/C 7, 8 (BEHIND LEFT END OF DASH)
LEFT POWER SLIDE DOOR ECU (IN LEFT SLIDING DOOR)
MPX
PNK/BLK WIRE
RED WIRE
RED/BLU WIRE
RIGHT POWER SLIDE DOOR ECU (IN RIGHT SLIDING DOOR)
SIL
SIL CANH SG CG
SKID CONTROL ECU W/ ACTUATOR (AT LEFT REAR OF ENGINE COMPT)
STEERING SENSOR (INSIDE STEERING COLUMN)
TRANSPONDER KEY COMPUTER (BEHIND UPPER CENTER OF DASH)
VIO WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YAW RATE SENSOR (UNDER RIGHT FRONT SEAT)
YEL/GRN WIRE
Go to component -> Computer data lines circuit -> DOOR ECU
