Toyota Sienna II (2003-2005) (at left rear quarterpanel) bm wiring diagram
This page shows the only wiring diagram for the component.(at left rear quarterpanel) bm, which is found in the car Toyota Sienna II (2003-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(at left rear quarterpanel) bm wiring diagram (1 of 1)
BLK/ WHT WIRE
BLK/RED WIRE
BRK RELAY
COLUMN)
CRUISE CONTROL) (IN ENGINE ROOM J/B)
DOOR
DRIVER SIDE J/B
ECU-IG FUSE
GAUGE 1 FUSE
GRN WIRE
GRN/BLK WIRE
GRN/WHT WIRE
GRN/YEL WIRE
HIGH MOUNTED STOP LIGHT
HOT AT ALL TIMES
HOT IN ON OR START
J/C 15 (BEHIND LEFT END OF DASH)
J/C 18 (BEHIND UPPER LEFT SIDE OF DASH)
J/C 2 (AT LEFT SIDE OF ENGINE COMPT)
J/C 31, 32 (BEHIND RIGHT SIDE OF DASH)
J/C 37 (FORWARD OF LEFT REAR WHEELWELL)
J/C 38 (BEHIND LEFT REAR QUARTERPANEL)
J/C 39 (IN BACK
J/C 41 (IN BACK DOOR)
LEFT LICENSE PLATE LIGHT
LEFT REAR COMBINATION LIGHT
R/B 6 (W/ DYNAMIC LASER
RED WIRE
RIGHT LICENSE PLATE LIGHT
RIGHT REAR COMBINATION
SKID CONTROL ECU WITH ACTUATOR (AT LEFT REAR OF ENGINE COMPT)
STOP FUSE
STOP LIGHT SWITCH (ON BRACKET, ABOVE BRAKE PEDAL)
STOP TAIL
STOP TAIL TURN TAIL
TURN TAIL LIGHT
W/ DYNAMIC LASER CRUISE CONTROL
W/O DYNAMIC LASER CRUISE CONTROL
WHT WIRE
WHT/ BLK WIRE
WHT/BLK WIRE
WHT/RED WIRE
Go to component -> Exterior lamps circuit (1 of 2) -> (AT LEFT REAR QUARTERPANEL) BM
