Toyota Sienna I (1997-2003) w/o pwr door locks wiring diagram
This page shows the only wiring diagram for the component.w/o pwr door locks, which is found in the car Toyota Sienna I (1997-2003). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
w/o pwr door locks wiring diagram (1 of 1)
2000- 2001
BACK-UP LIGHT RELAY (NEAR DRIVER SIDE J/B 1)
BACK-UP LIGHT SWITCH (ON TRANSAXLE)
CIG FUSE
DIODE (PARK/NEUTRAL POSITION SWITCH) (BEHIND CENTER OF DASH, TAPED TO HARNESS)
DRIVER SIDE J/B 1 (BEHIND DASH, LEFT OF STEERING COLUMN)
GAUGE FUSE
GRY WIRE
HOT IN ACC OR ON
HOT IN START OR ON
J/C 17 (BEHIND UPPER RIGHT SIDE OF DASH)
J/C 22 (RIGHT REAR CORNER OF VEHICLE)
J/C 7 (BEHIND TOP CENTER OF DASH)
LEFT BACK-UP LIGHT (LEFT REAR COMB LIGHT)
PNK WIRE
RED/BLK WIRE
RED/BLU WIRE
RIGHT BACK-UP LIGHT (RIGHT REAR COMB LIGHT)
W/ PWR DOOR LOCKS
W/O PWR DOOR LOCKS
WHT/BLK WIRE
Go to component -> Back-up lamps circuit -> W/O PWR DOOR LOCKS
