Toyota Sienna I (1997-2003) rear cooling blower resistor (on rear cooling unit) wiring diagram
This page shows the only wiring diagram for the component.rear cooling blower resistor (on rear cooling unit), which is found in the car Toyota Sienna I (1997-2003). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
rear cooling blower resistor (on rear cooling unit) wiring diagram (1 of 1)
0.22 OHMS
0.46 OHMS
0.86 OHMS
1.0 OHMS
1.68 OHMS
2.14 OHMS
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU WIRE
BLU/BLK WIRE
BLU/ORG WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
DRIVER SIDE R/B 5 (BEHIND LEFT SIDE OF DASH)
FRONT HEATER BLOWER SWITCH
GRN WIRE
GRY WIRE
GRY/RED WIRE
J/C 3 (BEHIND LEFT SIDE OF COMBINATION METER)
LT GRN WIRE
OFF
OFF LO
OFF REAR
ORG/ WIRE
PASSENGER SIDE R/B 3 (RIGHT REAR QUARTER PANEL)
REAR COOLING BLOWER MOTOR (ON REAR COOLING UNIT)
REAR COOLING BLOWER RESISTOR (ON REAR COOLING UNIT)
REAR HEATER BLOWER MOTOR (ON REAR HEATER UNIT)
REAR HEATER BLOWER RESISTOR (ON REAR HEATER UNIT)
REAR HEATER BLOWER SWITCH
REAR HEATER RELAY
REAR HI RELAY (ON RIGHT REAR OF VEHICLE)
REAR LO
REAR LO RELAY
REAR RELAY
RED WIRE
RED/BLU WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
WHT/RED WIRE
YEL/BLK WIRE
Go to component -> Manual a/c circuit, rear a/c (2 of 2) -> REAR COOLING BLOWER RESISTOR (ON REAR COOLING UNIT)
