Toyota Sienna I (1997-2003) j/c 2 (behind instrument cluster) wiring diagram
This page shows the only wiring diagram for the component.j/c 2 (behind instrument cluster), which is found in the car Toyota Sienna I (1997-2003). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
j/c 2 (behind instrument cluster) wiring diagram (1 of 1)
14 6 TC TS
26 46 42 TC D/G TS
ABS ACTUATOR, ECU (LEFT REAR OF ENGINE COMPT)
BLK WIRE
BLK/RED WIRE
BLK/YEL WIRE
BRN WIRE
BRN/WHT WIRE
CENTER AIR BAG SENSOR ASSEMBLY (BELOW CENTER OF DASH)
CRUISE CONTROL ECU (BEHIND LEFT CENTER OF DASH)
DATA LINK CONNECTOR 1 (RIGHT REAR CORNER OF ENGINE COMPT)
DATA LINK CONNECTOR 3 (BELOW DASH RIGHT OF STEERING COLUMN)
DRIVER SIDE J/B 1 (BEHIND DASH, LEFT OF STEERING COLUMN)
EFI FUSE
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
ENGINE ROOM J/B 2 (LEFT SIDE OF ENGINE COMPT) EFI RELAY
HOT AT ALL TIMES
J/B 3 (BEHIND INSTRUMENT CLUSTER)
J/C 14 (BEHIND RIGHT SIDE OF DASH)
J/C 17 (W/ VSC) (UPPER RIGHT SIDE OF DASH)
J/C 18 (W/ VSC) (ON UNDERSIDE OF STEERING COLUMN)
J/C 2 (BEHIND INSTRUMENT CLUSTER)
J/C 6 (BEHIND TOP CENTER OF DASH)
J/C 8 (BEHIND TOP CENTER OF DASH)
OBD FUSE
PNK/BLK WIRE
RED WIRE
RED/YEL WIRE
SIL
TRANSLATE ECU (W/ VSC) (UPPER LEFT END OF DASH)
VSC ECU (UPPER LEFT END OF DASH)
W/ VSC W/O VSC
WHT/BLK WIRE
Go to component -> Computer data lines -> J/C 2 (BEHIND INSTRUMENT CLUSTER)
