Toyota Sequoia I facelift (2004-2007) lt grn/red lt grn/red wiring diagram
This page shows the only wiring diagram for the component.lt grn/red lt grn/red, which is found in the car Toyota Sequoia I facelift (2004-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
lt grn/red lt grn/red wiring diagram (1 of 1)
13 3 MPX- MPX+
BH (AT LEFT "B" PILLAR)
BK (AT RIGHT "B" PILLAR)
BLK/RED WIRE
BLU/BLK WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BRN WIRE
COMBINATION METER
ENGINE HOOD COURTESY SWITCH (ON LEFT CENTER OF RADIATOR SUPPORT)
GRY WIRE
INSTRUMENT CLUSTER SYSTEM
INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH)
INTEGRATION CONTROL, PANEL (BEHIND CENTER OF DASH)
JUNCTION CONNECTOR 1 (ON RIGHT FRONT OF ENGINE COMPT)
JUNCTION CONNECTOR 10, 11 (BEHIND RIGHT END OF DASH)
JUNCTION CONNECTOR 29, 30 (LEFT KICK PANEL)
JUNCTION CONNECTOR 33, 34 (LEFT KICK PANEL)
JUNCTION CONNECTOR 44, 45 (RIGHT KICK PANEL)
JUNCTION CONNECTOR 8 (BEHIND LEFT END OF DASH)
LEFT REAR DOOR LOCK MOTOR, DOOR UNLOCK DETECTION SWITCH
LT GRN/BLK WIRE
LT GRN/RED LT GRN/RED WIRE
LT GRN/RED WIRE
PNK/BLK WIRE
PNK/BLU WIRE
RED/BLK WIRE
RED/YEL WIRE
RIGHT REAR DOOR LOCK MOTOR, DOOR UNLOCK DETECTION SWITCH
SECURITY
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
YEL WIRE
YEL/RED WIRE
Go to component -> Forced entry circuit (2 of 3) -> LT GRN/RED LT GRN/RED WIRE
