Rear wiper/washer circuit for Toyota Sequoia I (2000-2004)

1 10 11 IG WIG RWW 1 2 3 4 5 BECU BDR GND SIG 1 2 6 7 8 WIP- WIP+ SGND BACK DOOR ECU (ON LEFT SIDE OF LIFTGATE) BLK/RED WIRE BLU/BLK WIRE BLU/ORG WIRE BLU/RED WIRE BLU/WHT WIRE BLU/YEL WIRE BODY ECU (BEHIND LEFT END OF DASH) COMBINATION METER COMBINATION SWITCH ECU-B FUSE ECU-IG FUSE ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPT) GRN/BLK WIRE HOT AT ALL TIMES HOT IN RUN OR START INSTRUMENT PANEL J/B INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH) J/C 11 (BEHIND LEFT CENTER OF DASH) J/C 18 (BEHIND RIGHT END OF DASH) J/C 19 (LEFT SIDE OF REAR QUARTER PANEL) J/C 22 (ON LEFT SIDE OF LIFTGATE) LT GRN/RED WIRE OFF WASHER 1 ON INT ON INT OFF PWR 5 FUSE REAR WASHER MOTOR (ON RIGHT FRONT OF ENGINE COMPT, BEHIND HEADLIGHT) REAR WIPER MOTOR (INSIDE LOWER CENTER OF LIFTGATE) REAR WIPER/ WASHER SWITCH RWLS SUB J/B 3 (BEHIND RIGHT SIDE OF INSTRUMENT CLUSTER) WASHER 1 WASHER 2 WHT/BLK WIRE WHT/RED WIRE WSH FUSE YEL/BLK WIRE