Toyota Sequoia I (2000-2004) front stereo component amplifier wiring diagram
This page shows the only wiring diagram for the component.front stereo component amplifier, which is found in the car Toyota Sequoia I (2000-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
front stereo component amplifier wiring diagram (1 of 1)
1 LT
2 PNK WIRE
AMP
ANT
AUTO ANTENNA MOTOR RELAY (BEHIND LOWER CENTER OF DASH)
BEEP
BLK WIRE
BLU WIRE
BRN WIRE
ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPARTMENT)
ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPARTMENT) RAD 3 FUSE
FRONT STEREO COMPONENT AMPLIFIER
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ACC OR RUN
IF (BEHIND LEFT CENTER OF DASH,
ILLUM
INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH) RAD 2 FUSE
J/C 12 (BEHIND LEFT CENTER OF DASH)
J/C 14, J/C 15 (BEHIND RIGHT END OF DASH)
J/C 17 (BEHIND RIGHT END OF DASH)
J/C 8 (LEFT KICK PANEL)
J/C 9 (BEHIND LEFT END OF DASH)
LEFT FRONT DOOR SPEAKER, WOOFER
LEFT REAR DOOR SPEAKER
LEFT TWEETER SPEAKER
MUTE
NCA WIRE
PNK 2 WIRE
PNK PNK WIRE
PNK WIRE
RAD 1 FUSE
RADIO, PLAYER
REAR STEREO COMPONENT AMPLIFIER
RED WIRE
RIGHT FRONT DOOR SPEAKER, WOOFER
RIGHT REAR DOOR SPEAKER
RIGHT TWEETER SPEAKER
S GND
SHLD
SUB J/B 3 (BEHIND RIGHT SIDE OF INSTRUMENT CLUSTER)
VIO WIRE
WHT WIRE
YEL WIRE
Go to component -> Radio circuits, 10 speaker system -> FRONT STEREO COMPONENT AMPLIFIER
