Toyota Sequoia I (2000-2004) 1 2 3 4 5 becu bdr gnd sig wiring diagram
This page shows the only wiring diagram for the component.1 2 3 4 5 becu bdr gnd sig, which is found in the car Toyota Sequoia I (2000-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
1 2 3 4 5 becu bdr gnd sig wiring diagram (1 of 1)
1 10 11 IG WIG RWW
1 2 3 4 5 BECU BDR GND SIG
1 2 6 7 8 WIP- WIP+ SGND
BACK DOOR ECU (ON LEFT SIDE OF LIFTGATE)
BLK/RED WIRE
BLU/BLK WIRE
BLU/ORG WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BODY ECU (BEHIND LEFT END OF DASH)
COMBINATION METER
COMBINATION SWITCH
ECU-B FUSE
ECU-IG FUSE
ENGINE ROOM J/B (ON LEFT SIDE OF ENGINE COMPT)
GRN/BLK WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
INSTRUMENT PANEL J/B
INSTRUMENT PANEL J/B (BEHIND LEFT END OF DASH)
J/C 11 (BEHIND LEFT CENTER OF DASH)
J/C 18 (BEHIND RIGHT END OF DASH)
J/C 19 (LEFT SIDE OF REAR QUARTER PANEL)
J/C 22 (ON LEFT SIDE OF LIFTGATE)
LT GRN/RED WIRE
OFF WASHER 1
ON INT
ON INT OFF
PWR 5 FUSE
REAR WASHER MOTOR (ON RIGHT FRONT OF ENGINE COMPT, BEHIND HEADLIGHT)
REAR WIPER MOTOR (INSIDE LOWER CENTER OF LIFTGATE)
REAR WIPER/ WASHER SWITCH
RWLS
SUB J/B 3 (BEHIND RIGHT SIDE OF INSTRUMENT CLUSTER)
WASHER 1
WASHER 2
WHT/BLK WIRE
WHT/RED WIRE
WSH FUSE
YEL/BLK WIRE
Go to component -> Rear wiper/washer circuit -> 1 2 3 4 5 BECU BDR GND SIG
