Toyota RAV4 IV (2012-2015) knock control sensor (bank 1) shield wiring diagram
This page shows the only wiring diagram for the component.knock control sensor (bank 1) shield, which is found in the car Toyota RAV4 IV (2012-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
knock control sensor (bank 1) shield wiring diagram (1 of 1)
AIR CONDITIONING 4 SPEAKER, W/O PARK ASSIST) (CENTER OF DASH)
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
BD (REAR OF ENGINE)
BLK WIRE
BLK/ WHT WIRE
BRN WIRE
COMBINATION METER ASSEMBLY
CONDITIONING 4 SPEAKER, W/O PARK ASSIST
CONDITIONING 4 SPEAKER, W/O PARK ASSIST) (CENTER OF DASH)
CRANK POSITION SENSOR SHIELD
CRUISE CONTROL MAIN SWITCH
D/L P/ BACK OUTLET RELAY RELAY RELAY
D/UL
DATA LINK CONNECTOR 3
ECM SHIELD
ENGINE CONTROL MODULE
GA (LEFT KICK PANEL)
GB (LEFT SIDE OF DASH)
GE (RIGHT SIDE OF DASH)
GLASS BREAKAGE SENSOR ECU ASSEMBLY
IA (FRONT PASSENGER'S DOOR)
IGNITION COIL ASSEMBLY
INSTRUMENT PANEL J/B (LEFT END OF DASH)
JA (DRIVER'S DOOR)
KNOCK CONTROL SENSOR (BANK 1) SHIELD
LEFT FRONT DOOR OUTSIDE HANDLE ASSEMBLY
LEFT VANITY LIGHT SWITCH (LEFT VISOR ROOM ASSEMBLY) LIGHT ASSEMBLY 1
MAIN POWER D D/UL D/L BODY RELAY RELAY RELAY RELAY ECU
MAP LIGHT ASSEMBLY
NCA WIRE
RELAY
RELAY RELAY
SPIRAL CABLE (STEERING COLUMN)
STEERING SENSOR
TO GROUND GD (DIAGRAM 3 OF 4)
TRACTION CONTROL SWITCH
W/ CRUISE CONTROL
W/ SLIDING ROOF
WHT WIRE
WHT/BLK WIRE
Go to component -> Ground distribution circuit, except ev (2 of 4) -> KNOCK CONTROL SENSOR (BANK 1) SHIELD
