Toyota RAV4 III facelift (2010-2016) unlock warning switch (w/o smart key system) wiring diagram
This page shows the only wiring diagram for the component.unlock warning switch (w/o smart key system), which is found in the car Toyota RAV4 III facelift (2010-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
unlock warning switch (w/o smart key system) wiring diagram (1 of 1)
CTY
CTY GND
DOME CUT RELAY
GB (LEFT SIDE OF DASH)
GD (CENTER OF DASH)
GND CTY
GRY WIRE
IGNITION KEY CYLINDER LIGHT
J/C 1 (LEFT SIDE
J/C 5 (CENTER OF DASH)
LEFT VANITY LIGHT ASSEMBLY
LEFT VANITY LIGHT SWITCH (LEFT VISOR ASSEMBLY)
LT BLU WIRE
MAP LIGHT ASSEMBLY
OF DASH)
PNK PNK 1 2 WIRE
PNK WIRE
R/B 5 (LEFT END OF DASH)
RED WIRE
RIGHT VANITY LIGHT ASSEMBLY
RIGHT VANITY LIGHT SWITCH (RIGHT VISOR ASSEMBLY)
ROOM LIGHT ASSEMBLY 1
TRANSPONDER KEY COIL (W/O SMART KEY SYSTEM)
UNLOCK WARNING SWITCH (W/O SMART KEY SYSTEM)
W/ SLIDING ROOF
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Courtesy lamps circuit, except ev (2 of 2) -> UNLOCK WARNING SWITCH (W/O SMART KEY SYSTEM)
