Toyota RAV4 III facelift (2010-2016) (separate type amplifier) multi-media module receiver assembly wiring diagram
This page shows the only wiring diagram for the component.(separate type amplifier) multi-media module receiver assembly, which is found in the car Toyota RAV4 III facelift (2010-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(separate type amplifier) multi-media module receiver assembly wiring diagram (1 of 1)
AIR BAG SENSOR ASSEMBLY
AIR CONDITIONING 4 SPEAKER, W/O PARK ASSIST) (CENTER OF DASH)
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
BD (REAR OF ENGINE)
BLK WIRE
BLK/ WHT WIRE
BRN WIRE
COMBINATION METER ASSEMBLY
CONDITIONING 4 SPEAKER, W/O PARK ASSIST
CONDITIONING 4 SPEAKER, W/O PARK ASSIST) (CENTER OF DASH)
CRANK POSITION SENSOR SHIELD
CRUISE CONTROL MAIN SWITCH
D D/UL D/L RELAY RELAY
D/L P/ BACK OUTLET RELAY RELAY RELAY
D/UL
DATA LINK CONNECTOR 3
ECM SHIELD
ENGINE CONTROL MODULE
GA (LEFT KICK PANEL)
GB (LEFT SIDE OF DASH)
GE (RIGHT SIDE OF DASH)
IA (FRONT PASSENGER'S DOOR)
IGNITION COIL ASSEMBLY
INSTRUMENT PANEL J/B (LEFT END OF DASH)
J/C 10
J/C 5
JA (DRIVER'S DOOR)
KNOCK CONTROL SENSOR (BANK 1) SHIELD
MAIN
MAP LIGHT ASSEMBLY
NCA WIRE
POWER BODY RELAY RELAY RELAY RELAY ECU
RELAY
SPIRAL CABLE (STEERING COLUMN)
STEERING SENSOR
TO GROUND GD (DIAGRAM 3 OF 4)
TRACTION CONTROL SWITCH
W/ CRUISE CONTROL
W/ SLIDING ROOF
WHT WIRE
WHT/BLK WIRE
Go to component -> Ground distribution circuit, except ev (2 of 4) -> (SEPARATE TYPE AMPLIFIER) MULTI-MEDIA MODULE RECEIVER ASSEMBLY
