Toyota RAV4 III (2005-2010) radio receiver overhead assembly j/b shield wiring diagram
This page shows the only wiring diagram for the component.radio receiver overhead assembly j/b shield, which is found in the car Toyota RAV4 III (2005-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
radio receiver overhead assembly j/b shield wiring diagram (1 of 1)
A/C COMPRESSOR
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
AIR FUEL RATIO SENSOR (BANK 2 SENSOR 1) SHIELD
BRN WIRE
CANISTER PUMP A/C MODULE COMPRESSOR
CANISTER PUMP MODULE
CRANKSHAFT POSITION SENSOR SHIELD
DATA LINK CONNECTOR
DRIVER'S SIDE POWER SEAT SWITCH
ENGINE CONTROL MODULE
EXCEPT JBL
FUEL YAW RATE SUCTION PUMP SENSOR
HEATED OXYGEN SENSOR (BANK 1 SENSOR 2) SHIELD
HEATED OXYGEN SENSOR (BANK 2 SENSOR 2) SHIELD
J/B 3 (LEFT SIDE OF DASH)
J/C
KNOCK CONTROL SENSOR (BANK 1), KNOCK CONTROL SENSOR (BANK 2) SHIELD
LEFT "C" PILLAR)
LEFT REAR COMBINATION LAMP
NCA WIRE
POWER SEAT LEFT SWITCH SEAT (LUMBAR HEATER SUPPORT)
POWER STEERING ECU
RADIO RECEIVER OVERHEAD ASSEMBLY J/B SHIELD
REAR POWER COMBINATION OUTLET LAMP SOCKET
RIGHT REAR
SPIRAL CABLE
VOLTAGE INVERTER
WHT/BLK WIRE
Go to component -> Ground distribution circuit (3 of 3) -> RADIO RECEIVER OVERHEAD ASSEMBLY J/B SHIELD
