Toyota RAV4 II facelift (2003-2006) single pressure switch wiring diagram
This page shows the only wiring diagram for the component.single pressure switch, which is found in the car Toyota RAV4 II facelift (2003-2006). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
single pressure switch wiring diagram (1 of 1)
A/C CONDENSER FAN MOTOR (BEHIND LEFT SIDE OF RADIATOR)
A/C TRIPLE PRESSURE SWITCH (AT RIGHT FRONT CORNER OF ENGINE COMPARTMENT)
ACMG
BLK (OR WHT) WIRE
BLK WIRE
BLU WIRE
BRN WIRE
CDS FUSE
DIODE (FAN) (BEHIND RIGHT SIDE OF DASH)
DUAL PRESSURE SWITCH
ED (AT FRONT OF LEFT FRONT FENDER)
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
ENGINE CONTROLS SYSTEM
ENGINE COOLANT TEMPERATURE SENSOR (ON REAR OF ENGINE)
ENGINE ROOM J/B (AT LEFT SIDE OF ENGINE COMPARTMENT)
FAN
FAN 1 RELAY
FAN 2 RELAY
FAN 3 RELAY
FROM HTR RELAY (DIAGRAM 1 OF 2)
HOT AT ALL TIMES
LT GRN WIRE
LT GRN/BLK WIRE
LT GRN/RED WIRE
RADIATOR FAN MOTOR (BEHIND LEFT SIDE OF RADIATOR)
RDI FUSE
RED (OR WHT) WIRE
RED WIRE
RED/BLU WIRE
RED/YEL (OR WHT) WIRE
RED/YEL WIRE
SINGLE PRESSURE SWITCH
TACH
WHT WIRE
WHT/BLK WIRE
YEL/GRN (OR WHT) WIRE
Go to component -> Manual a/c circuit (2 of 2) -> SINGLE PRESSURE SWITCH
