Toyota Prius III facelift (2011-2015) (if equipped) navigation receiver assembly wiring diagram
This page shows the only wiring diagram for the component.(if equipped) navigation receiver assembly, which is found in the car Toyota Prius III facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(if equipped) navigation receiver assembly wiring diagram (1 of 1)
BACK DOOR OPENER SWITCH ASSEMBLY
BLK/WHT WIRE
BRAKE FLUID LEVEL WARNING SWITCH (BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY)
BRN WIRE
CENTER STOP LIGHT REAR (CENTER WIPER STOP MOTOR LIGHT SET) ASSEMBLY
DCM (TELEMATICS TRANSCEIVER)
FROM INSTRUMENT PANEL J/B (DIAGRAM 4 OF 4)
FUEL SENDER GAGE ASSEMBLY
HEADLIGHT CLEANER RELAY
LEFT "C" PILLAR)
LEFT BACK LICENSE DOOR LOCK PLATE LIGHT ASSEMBLY ASSEMBLY
LEFT REAR COMBINATION LIGHT ASSEMBLY
LEFT REAR DOOR W/ MOTOR LOCK ASSEMBLY
LEFT SEAT HEATER CONTROL SUB-ASSEMBLY
LUMBAR SUPPORT SWITCH (POWER SEAT SWITCH ASSEMBLY)
OPTION CONNECTOR (ENGINE HOOD COURTESY SWITCH ASSEMBLY)
PARKING ASSIST ECU
REAR WINDOW RIGHT DEFOGGER LICENSE (BACK DOOR PLATE LIGHT GLASS) ASSEMBLY
RIGHT END OF DASH)
SKID CONTROL ECU W/ ACTUATOR ASSEMBLY
SLIDING ROOF DRIVE GEAR ASSEMBLY
STEREO COMPONENT AMPLIFIER ASSEMBLY
STOP LIGHT CONTROL ECU
WHT/BLK (OR BRN) WIRE
WHT/BLK WIRE
WIRELESS DOOR LOCK BUZZER
Go to component -> Ground distribution circuit (1 of 4) -> (IF EQUIPPED) NAVIGATION RECEIVER ASSEMBLY
