Toyota Prius III facelift (2011-2015) cgnd cv- canl canh wiring diagram
This page shows the only wiring diagram for the component.cgnd cv- canl canh, which is found in the car Toyota Prius III facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
cgnd cv- canl canh wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 B(+)
BATT NAV PNK WIRE
BLK WIRE
BLU WIRE
BRN WIRE
CB+
CB+ CV+
CGND
CGND CV- CANL CANH
COMPUTER DATA LINES SYSTEM
CV+
ECU-ACC FUSE
ECU-IG 2 FUSE
ENGINE ROOM J/B (LEFT SIDE OF ENGINE COMPT)
GAUGE FUSE (BEHIND LEFT END OF DASH)
GRN WIRE
GRY WIRE
GVIF
HEADLIGHT LEVELING ECU ASSEMBLY (BEHIND RIGHT END OF DASH)
HOT AT ALL TIMES
HOT AT ALL TIMES ENGINE P/I 2 ROOM R/B FUSE (LEFT SIDE OF ENGINE COMPT)
HOT W/ ACC RELAY ENERGIZED
IG+ PNK WIRE
INSTRUMENT PANEL J/B
INTEGRATION RELAY
ISSW HBL+ HB+ HGND HBE+ PNK WIRE
LEFT ULTRASONIC SENSOR 1 (LEFT FRONT OF ENGINE COMPT)
LIN 3
LT BLU WIRE
NAVIGATION RECEIVER ASSEMBLY (UNDER REAR OF CENTER CONSOLE)
NCA WIRE
ORG/ WIRE
PARKING ASSIST ECU (BEHIND RIGHT SIDE OF DASH)
PARKING ASSIST PRE SUPPORT
PNK WIRE
RAD 1 FUSE
REAR TELEVISION CAMERA ASSEMBLY (LEFT SIDE OF LIFTGATE)
RED WIRE
RELAY ENERGIZED
REV
RIGHT END OF DASH)
RIGHT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (RIGHT SIDE OF REAR AXLE)
RIGHT ULTRASONIC SENSOR 1 (RIGHT FRONT OF ENGINE COMPT)
SBR
SGR
SHB
SHG
SHRL
SHRR
SWITCH ASSEMBLY
TX- TX+
VIO WIRE
W/ HEADLIGHT BEAM LEVEL CONTROL
W/O HEADLIGHT BEAM LEVEL CONTROL
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Parking assistant circuit -> CGND CV- CANL CANH
