Toyota Prius III facelift (2011-2015) canister pressureure sensor wiring diagram
This page shows the only wiring diagram for the component.canister pressureure sensor, which is found in the car Toyota Prius III facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
canister pressureure sensor wiring diagram (1 of 1)
+BM
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BRN WIRE
CANISTER PRESSUREURE SENSOR
EFI FUSE 2
ENGINE CONTROL MODULE (ECM) (CENTER REAR OF ENGINE COMPT)
ENGINE ROOM R/B 2 (LEFT SIDE OF ENGINE COMPT)
FUEL SUCTION TUBE ASSEMBLY W/ PUMP, GAGE
FUSE
FUSE 2
GRN WIRE
GRY WIRE
HOT IN ON OR START
LEAK DETE- CTION PUMP
LT GRN WIRE
ORG/ WIRE
PNK WIRE
PUMP
RED WIRE
VENT VALVE
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 1.5l, engine controls circuit (2 of 6) -> CANISTER PRESSUREURE SENSOR
