Toyota Prius III (2009-2011) oxygen sensor (bank 1 sensor 2) (right rear of engine) wiring diagram
This page shows the only wiring diagram for the component.oxygen sensor (bank 1 sensor 2) (right rear of engine), which is found in the car Toyota Prius III (2009-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
oxygen sensor (bank 1 sensor 2) (right rear of engine) wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BRN WIRE
EKNK ETA EPPM VCPP PPMP
ENGINE CONTROL MODULE (ECM) (LEFT SIDE OF ENGINE COMPT)
EPIM VCPM
ETHA VG
GRN WIRE
GRY WIRE
IGF
IGNITION COIL ASSEMBLY 1
IGNITION COIL ASSEMBLY 2
IGNITION COIL ASSEMBLY 3 (TOP OF ENGINE)
IGNITION COIL ASSEMBLY 4
LT GRN WIRE
MASS AIR FLOW METER (LEFT SIDE OF ENGINE)
NCA WIRE
NE+
OXYGEN SENSOR (BANK 1 SENSOR 2) (RIGHT REAR OF ENGINE)
PIM
PNK THA WIRE
PNK THW ETHW WIRE
PNK WIRE
RED WIRE
THA
TOP OF ENGINE)
VVI+
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 1.8l, engine controls circuit (4 of 4) -> OXYGEN SENSOR (BANK 1 SENSOR 2) (RIGHT REAR OF ENGINE)
