Toyota Prius III (2009-2011) brake pedal stroke sensor assembly shield wiring diagram
This page shows the only wiring diagram for the component.brake pedal stroke sensor assembly shield, which is found in the car Toyota Prius III (2009-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
brake pedal stroke sensor assembly shield wiring diagram (1 of 1)
BRAKE BOOSTER PUMP ASSEMBLY
BRAKE PEDAL STROKE SENSOR ASSEMBLY SHIELD
BRN WIRE
ENGINE CONTROL MODULE (ECM)
FAN RELAY 2
HEADLIGHT LEVELING ECU ASSEMBLY
IGCT RELAY
INVERTER WATER (LED TYPE) PUMP LEFT MOTOR HEADLIGHT ASSEMBLY ASSEMBLY
LEFT FRONT SPEED SENSOR SHIELD
LEFT REAR SPEED SENSOR SHIELD
LEFT RIGHT FRONT FRONT TURN TURN SIGNAL SIGNAL LIGHT LIGHT
NCA WIRE
POWER STEERING ECU ASSEMBLY
RELAY
RIGHT END OF DASH)
RIGHT FRONT SPEED SENSOR SHIELD
RIGHT LEFT FOG FOG LIGHT LIGHT ASSEMBLY ASSEMBLY
RIGHT REAR SPEED SENSOR SHIELD
SKID CONTROL ECU W/ ACTUATOR ASSEMBLY
TRANSMISSION CONTROL ECU ASSEMBLY
W/ CONVERTER INVERTER ASSEMBLY
W/ MOTOR COMPRESSOR ASSEMBLY
WHT WIRE
WHT/BLK WIRE
WINDSHIELD WIPER MOTOR ASSEMBLY
Go to component -> Ground distribution circuit (2 of 4) -> BRAKE PEDAL STROKE SENSOR ASSEMBLY SHIELD
