Toyota Prius II (2003-2005) 2 7 1 sil canl canh wiring diagram
This page shows the only wiring diagram for the component.2 7 1 sil canl canh, which is found in the car Toyota Prius II (2003-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
2 7 1 sil canl canh wiring diagram (1 of 1)
14 30 31 PNK TC CANL CANH WIRE
19 18 CANL CANH
2 3 CANL CANH
2 7 1 SIL CANL CANH
32 28 18 19 TS D/G CANL CANH
6 9 8 PNK TC CANL CANH WIRE
9 10 CANL CANH
A/B TS TC CANL
BATTERY ECU (ABOVE LEFT REAR WHEELWELL, NEAR SYSTEM MAIN RELAY)
BLK WIRE
BLU WIRE
BRN WIRE
CG SG CANH SIL
DATA LINK CONNECTOR (DLC) 3 (BEHIND LOWER LEFT SIDE OF DASH)
ENGINE CONTROL MODULE (BEHIND RIGHT END OF DASH)
GATEWAY ECU (BEHIND UPPER CENTER OF DASH)
GRN WIRE
GRY WIRE
GTX-
HYBRID VEHICLE CONTROL ECU (BEHIND RIGHT SIDE OF DASH)
IH (ABOVE LEFT KICK PANEL)
J/C 15 (BEHIND LEFT END OF DASH)
J/C 16 (BEHIND LEFT END OF DASH)
J/C 17 (AT RIGHT KICK PANEL)
J/C 18 (AT RIGHT KICK PANEL)
J/C 24 (BEHIND LEFT END OF DASH)
J/C 25 (BEHIND LEFT END OF DASH)
NCA WIRE
PNK PNK WIRE
PNK WIRE
POWER STEERING ECU (BEHIND LEFT SIDE OF DASH)
SIL
SKID CONTROL ECU (BEHIND LEFT SIDE OF DASH)
STEERING SENSOR (ON STEERING COLUMN)
WHT WIRE
WHT/BLK WIRE
YAW RATE SENSOR (BELOW CENTER CONSOLE)
YEL WIRE
Go to component -> Computer data lines circuit (1 of 2) -> 2 7 1 SIL CANL CANH
