Toyota MR2 W30 (1999-2007) junction connector 6 (at base of right door opening) wiring diagram
This page shows the only wiring diagram for the component.junction connector 6 (at base of right door opening), which is found in the car Toyota MR2 W30 (1999-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
junction connector 6 (at base of right door opening) wiring diagram (1 of 1)
BK (NEAR RIGHT DOOR STRIKER)
BLK WIRE
BLU WIRE
BODY ECU (BEHIND LEFT SIDE OF DASH)
BRN WIRE
BUZZER
COMBINATION METER
COMBINATION SWITCH
DCTY
DOME FUSE
DOOR FUSE
DOOR IND
ECU-B FUSE
GAUGE FUSE
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
HTR FUSE
IE (AT LEFT KICK PANEL)
IF (BEHIND LEFT CENTER OF DASH, ON BRACE)
IH (AT RIGHT KICK PANEL)
J/B 6 (BEHIND CENTER OF DASH)
JUNCTION CONNECTOR 3, 4 (BEHIND RIGHT END OF DASH)
JUNCTION CONNECTOR 6 (AT BASE OF RIGHT DOOR OPENING)
LEFT BUCKLE SWITCH, TENSION REDUCER (UNDER DRIVER'S SEAT)
LEFT DOOR COURTESY SWITCH
LIGHT CONTROL SWITCH
OFF HEAD TAIL
ORG/ WIRE
PANEL FUSE
PCTY
R/B 3 (BEHIND LEFT CORNER OF DASH)
RED WIRE
RIGHT DOOR COURTESY SWITCH (LOWER RIGHT "B" PILLAR)
SEAT BELT WARNING INDICATOR
SOLID STATE
TAIL 1 FUSE
TAIL RELAY
UNLOCK WARNING SWITCH
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Warning systems circuit -> JUNCTION CONNECTOR 6 (AT BASE OF RIGHT DOOR OPENING)
