Toyota MR2 W30 (1999-2007) ehps relay wiring diagram
This page shows the only wiring diagram for the component.ehps relay, which is found in the car Toyota MR2 W30 (1999-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
ehps relay wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 IDUP SPD TC
1 2 3 4 IGB SIL
1 2 MH PGND
BL (ON LEFT FRONT STRUT TOWER)
BLK WIRE
BLK/RED WIRE
BLU WIRE
BLU/ORG WIRE
BM (ON LEFT FRONT STRUT TOWER)
BRN WIRE
COMBINATION METER
DATA LINK CONNECTOR (DLC) 3 (BELOW LEFT END OF DASH)
ECU-IG FUSE
EHPS FUSE
EHPS RELAY
ENGINE CONTROL MODULE (BEHIND DRIVER'S SEAT, ON PANEL)
GAUGE FUSE
GRN WIRE
GRN/RED WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IE (AT LEFT KICK PANEL) IE (AT LEFT KICK PANEL)
IH (AT RIGHT KICK PANEL)
J/B 6 (BEHIND CENTER OF DASH)
MRLY EFI TS
ORG/ WIRE
PNK WIRE
PNK/BLK WIRE
POWER STEERING ECU (ON LEFT SIDE OF FRONT COMPT)
POWER STEERING WARNING LIGHT
PSCT
R/B 3 (BEHIND LEFT CORNER OF DASH)
R/B 4 (IN FRONT COMPT, ON LEFT FRONT FENDERWELL)
RED WIRE
SIL
VIO WIRE
VIO/WHT WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
Go to component -> Electronic power steering circuit -> EHPS RELAY
