Toyota Highlander III (2013-2016) compressor w/ pulley assembly (left front of engine) wiring diagram
This page shows the only wiring diagram for the component.compressor w/ pulley assembly (left front of engine), which is found in the car Toyota Highlander III (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
compressor w/ pulley assembly (left front of engine) wiring diagram (1 of 1)
3.5L
4 2 1 7 5 6 CLTS CLTE CLTB
A/C PRESSURE SENSOR (RIGHT FRONT ENGINE COMPT)
AC (LEFT FRONT CORNER OF ENGINE COMPT)
ACOP
ACOS
AUTOMATIC LIGHT CONTROL SENSOR (UNDER TOP CENTER
BLK WIRE
BLU WIRE
BRN WIRE
COMPRESSOR W/ PULLEY ASSEMBLY (LEFT FRONT OF ENGINE)
DEFS
FC (RIGHT KICK PANEL)
FF (CENTER OF DASH)
FRONT BLOWER W/ FAN MOTOR (UNDER RIGHT SIDE OF DASH)
GRN WIRE
GROUND J/C 2 (LEFT FRONT CORNER OF ENGINE COMPT)
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES ENGINE ROOM R/B 1 (LEFT SIDE OF ENGINE COMPT)
HTR FUSE
IGN
LT BLU WIRE
LT GRN WIRE
MG+
OF DASH)
OUTSIDE TEMPERATURE SENSOR (THERMISTOR ASSEMBLY) (BEHIND CENTER OF FRONT BUMPER)
PNK 1 2 WIRE
PNK PNK WIRE
PNK WIRE
PTC HTR 1 FUSE
PTC HTR 1 RELAY
PTC HTR 2 FUSE
PTC HTR 2 RELAY
PTC HTR 3 FUSE
PTC HTR 3 RELAY
RED WIRE
SOL +
SOLAR SENSOR
SSR+
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> A/c circuit, except hybrid (2 of 3) -> COMPRESSOR W/ PULLEY ASSEMBLY (LEFT FRONT OF ENGINE)
