Toyota Highlander II facelift (2010-2013) (w/o multi information display) clock assembly wiring diagram
This page shows the only wiring diagram for the component.(w/o multi information display) clock assembly, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(w/o multi information display) clock assembly wiring diagram (1 of 1)
3.5L
A/C AMPLIFIER ASSEMBLY
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1) SHIELD
AIR FUEL RATIO SENSOR (BANK 2 SENSOR 1) SHIELD
BLK/ WHT WIRE
BRN WIRE
CANISTER PUMP SPIRAL CABLE MODULE ECM SUB- ASSEMBLY (IN STEERING COLUMN)
CENTER AIR BAG SENSOR ASSEMBLY
COMBINATION METER
CRANK- SHAFT POSITION SENSOR SHIELD
CRUISE CONTROL MAIN SWITCH
DLC 3
DOOR CONTROL LOCK SWITCH ASSEMBLY ASSEMBLY
FRONT BLOWER W/ FAN MOTOR SUB- ASSEMBLY
HEADLIGHT DIMMER SWITCH ASSEMBLY
IGNITION COIL ASSEMBLY
IGNITION IGNITION COIL COIL ASSEMBLY ASSEMBLY
IGNITION IGNITION IGNITION COIL COIL COIL ASSEMBLY ASSEMBLY ASSEMBLY
KNOCK CONTROL SENSOR (BANK 1, 2) SHIELDS
LEFT FOG LIGHT ASSEMBLY
LEFT FRONT TURN SIGNAL LIGHT (LEFT HEADLIGHT ASSEMBLY)
LEFT HEADLIGHT ASSEMBLY
NCA WIRE
OXYGEN SENSOR (BANK 1 SENSOR 2) SHIELD
OXYGEN SENSOR (BANK 2 ECM SENSOR 2) SHIELD
PATTERN SELECT SWITCH ASSEMBLY 1
POWER STEERING ECU ASSEMBLY
RIGHT FRONT DOOR W/ MOTOR
RIGHT OUTER REAR VIEW MIRROR ASSEMBLY
RIGHT REAR OCCUPANT DOOR W/ MOTOR DETECTION LOCK ASSEMBLY ECU
TIRE PRESSURE WARNING ECU
VSC OFF SWITCH
W/ MIRROR HEATER, W/O OUTER MIRROR FOOT LIGHT
W/ OUTER MIRROR FOOT LIGHT
W/ REAR A/C
WHT WIRE
WHT/ BLK WIRE
WHT/BLK WIRE
WINDSHIELD WIPER MOTOR ASSEMBLY
Go to component -> Ground distribution circuit, except hybrid (3 of 5) -> (W/O MULTI INFORMATION DISPLAY) CLOCK ASSEMBLY
