Toyota Highlander II facelift (2010-2013) (under rear of vehicle) canister pump module wiring diagram
This page shows the only wiring diagram for the component.(under rear of vehicle) canister pump module, which is found in the car Toyota Highlander II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(under rear of vehicle) canister pump module wiring diagram (1 of 1)
18 19 PNK WIRE
BLK WIRE
BLK/RED WIRE
BLU WIRE
BRN WIRE
CANISTER PRESSURE SENSOR
COMPUTER
DATA LINES
GRN WIRE
GRY WIRE
INTAKE AIR CONTROL VALVE ACTUATOR (REAR OF ENGINE)
LEAK DETECTION PUMP
LT BLU WIRE
LT GRN WIRE
MASS AIR FLOW METER (LEFT REAR OF ENGINE COMPT)
NCA WIRE
ORG/ WIRE
OUT
PATTERN SELECT SWITCH ASSEMBLY 1
PNK WIRE
RED WIRE
RED/WHT WIRE
SKID CONTROL ECU W/ ACTUATOR (RIGHT FRONT OF ENGINE COMPT)
SYSTEM
THA
VDD
VENT VALVE
VIO WIRE
VVE-
VVT SENSOR (BANK 1 EXHAUST) (REAR OF ENGINE)
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 2.7l (4 of 5) -> (UNDER REAR OF VEHICLE) CANISTER PUMP MODULE
